 |
INITIAL ’CHUTE PREPARATION Measure each shroud line and make a mark at the midpoint. Loosely tie the shroud lines at the end into a simple overhand knot, making sure the marks you made stay together. |
 |
Holding the shroud lines at the midpoint marks to make sure they stay together, pull the knot tight, leaving a small loop at the end of the tied lines. |
 |
PREPARATION FOR FLIGHT Fold the chute panel-over-panel as shown, then lay the shroud lines on the folded chute leaving the knot and loop just below the chute. |
 |
Now fold the chute in half twice over the shroud lines, capturing them inside the chute. |
 |
Fold the top third of the chute over lengthwise... |
 |
...then fold it lengthwise again. |
 |
Attach the chute to the shock cord, kwik-link, or other attachment point on the rocket at the loop. |
 |
Load the shock cord into the airframe, then push in the chute bundle shroud line end first, just far enough to allow easy installation of the nosecone or payload section. |
** Please note PML products are for resale in Canada only**
